Both wrong, I'm afraid, but the suggestions were funny :)

They weren't loading to start with, but now they appear to be ok.

@CeeJæy A method you might not have tried is to draw the river as a line, and then cut it into sections along it's length and use Change Properties to gradually reduce the width towards the source. It takes a little time to do if you have lots of rivers but the effect is genearally well worth it. The more sections you cut it into the more gradually you can change the line width and the smoother the outcome.

There's something prowling around at the stones, so better not go out today.

Wyvern - It's a polygon on a sheet with an EFI, so it can be drawn with as much or as little detail as you like.

Jeff - Yes, it is a bit flat. I hope to be able to go back to them if I have time.

Like this, @Wyvern ?

I've had to change the order of the sheets a bit so the shadow is on top of the cliff and enabled me to put the CLIFF blend sheet between it and the cliff symbols.