If you want, I can host it on my server along with the archived websites.

Unfortunately, there are some holes in my archives because Jim had to change servers a few years back and not all of his migration back then were complete, so his sites had a lot of missing links, which obviously also made it into my archived version in the same condition. I don't think he even migrated all of the older sites at all, leaving them unable for me to archive since the old hosting went down years ago.

Thanks. That should complete this set.

Fixed. Turned out you had been a bad boy. There was an apostrophe in the map filename, but not in the pdf one.....

Added most of these, except wagon stop for now.

Not sure what would cause the numbering. I am unable to reproduce that behavior myself. Note that it will only put numbers in fully complete hexes, so the rightmost row is expected to not have labels, even if they are mostly complete, they are not fully complete, and that is what CC3+ looks for. But I am honestly not sure why the A00 label is missing; from the other labels is clear that CC3+ sees that there is a hex there. On all my own tests, that one appear just fine. Could you post the .fcw file you are using where you experience this issue?

As for the missing line in the top left, I notice that sometimes happen if the hex is incomplete, as in your example there, it is missing the rightmost edge node where that line should end. Not sure why/when this happens, but since it is just a single line, the quickest fix is probably just to put it in my hand, just place a line on the same sheet and layer as the existing grid lines. The grid is really just a series of lines anyway. The same is probably the easiest fix for the numbering as well, just copy one of the existing number labels into place and use :CC2EDIT: to change the text. This also allow you to manually add labels to those incomplete hexes as well if you want. Keep in mind that the grid is normally grouped by default, but you can temporary unlock groups with the "Locked" button in the lower right of the GUI and temporarily unfreeze the HEX/SQUARE grid layer from the layers dialog so you can work with it.