Very nice. You've come quite a way in how you present these maps. The division into different zones doesn't look as jarring as it did in your early maps. While the zoning is still visible (which I know is your intent), the entire map still feel quite natural.

And here we go, now part of the atlas. Thanks Shessar.

Lovely. I always enjoy visiting historic sites. Hope you had an enjoyable visit, even if it was a bit on the short side.

Maybe you could drop by Norway one day, I have a lot of hills here I need flattened....

Dragon's lair now added to the atlas.

@Ricko Hasche I wasn't able to include the dragon map, as it contains unknown symbols. You'll need to edit it and replace these before I can use it in the atlas.

 $____recursos mapas\MIKE SCHLEY PRESETS\arvore fogueira buraco\SS_TS005_006_Ground_Burned_Small_02_LG.png

 $____recursos mapas\MIKE SCHLEY PRESETS\arvore fogueira buraco\SS_TS005_037_Smoke_Small_02_LG.png

Also, please make sure to check the scaling on your maps. A couple of them was badly scaled. For example, the scale bar in the Burned Emptiness was off, showing 200 while it should have been 100, while the actual map was correctly scaled (determined by looking at how it fit in on the overview map of the region). Some other maps had the opposite, where the scale bar values was logical, but the map itself was wrongly scaled.

You can easily check that the map and the scale bar matches up by using Info ->Distance and just measuring along the length of the scale bar. CC3+ should return a value equal to the length of your scalebar, if not, one of them is scaled wrong. You then need to determine if it is the scale bar (if so, you can just relabel the length on it) or the map itself, in which case you need to re-scale it.

I also believe that some of the maps have both a wrong scale bar and incorrectly scaled, as the length of the scale bar is correct when measured, but they don't seem to fit correctly in on the main regional map when plotted in at the correct size. This applies to the Hafr and Laugar maps.

Note that if you need to make changes to the maps I have already included in the atlas, it is important that you edit the files from the atlas, and not your own originals as that would delete the work I have already done in integrating them.