I talked myself into making an under water, eastern most underground lake, area. The plain bitmap fill works for land, but it should be rougher under the water. And there are no isometric rocks.

about 500' x 400'

I may just do this as an overhead view...

Any suggestions to fix this up as an isometric map ?

Preliminary map for Water Town, lower. An area of crime, and danger.

Note the algae covered rocks. No giant snail wranglers will come down here to clean the algae off the rocks. And notice the cloudy water.

You've never heard of them ? Well, since I just made them up, I'm not surprised. Need some giant snail symbols that are Isometric and Atlas ready...

Local rules for both water towns, no swimming over a building. Must use entrances and walkways.

Alyssa Faden is Annual 95.

pyramid

first level 191' x 529'

second level 436' x 720'

third level 957' x 1110'

fourth level 1588' x 1796'

fifth level 2414' x 2600'

sixth level 3430' x 3532'

seventh level 4396' x 4400'

measured on this map's fcw.

I make, as an example, a village map for a particular nation in my game world. Then I go into the symbol manager and save those symbols as a symbol catalog,.fsc

Next time I make a village in that nation, I load that fsc and start mapping.

Edit. Fixed a sentence.

And now, if the characters get to the correct portal, and figure out how to get these closeup areas to get them to the arcology area...

And here is the 'local area'. in some other locale. Not actually on Crestar.

Scorched keep, with a pit door for going down into the tunnels below.

Is this a bit busy ?

I noticed a mistake in 2 maps. Similar names so I changed them up.

As for a set of particular symbols for say villages in a particular nation... I make a map of a typical village for that nation.

Then go into Symbol Manager and save all of them into a catalog. 'nationname_village.fsc as an example.

Next time I want to map a village in that nation, I load that symbol file.

I only have Win 10.