This has been an on going project but I think I'll be printing in large quantities very soon.
First tile has a floor token on it
Next flip the token over
Next flip the tile over
It took a while to get the grid just the way I wanted. I think I got the balance now. Plus the grid now only shows where the floor is, so you wont see it in pillars, earthen areas, etc.
1) Wall Shadows don't always align. 2) My daughters did not clean the table after lunch (sorry about that) 3) I need to print a lot more! 4) I need to edge them in black
Other than that I'm really pleased with the design!
Comments
First tile has a floor token on it
Next flip the token over
Next flip the tile over
It took a while to get the grid just the way I wanted. I think I got the balance now. Plus the grid now only shows where the floor is, so you wont see it in pillars, earthen areas, etc.
Problems
1) Wall Shadows don't always align.
2) My daughters did not clean the table after lunch (sorry about that)
3) I need to print a lot more!
4) I need to edge them in black
Other than that I'm really pleased with the design!
Since the wall shadows don't align I would get rid of them. Maybe replace them with a dark edge glow to make them stand out.
Thanks,
Miri