Sewer Dungeon Tiles?

Trenloe · August 2011

Hi everyone, I'm looking for some advice...

I need to create some dungeon tiles for a convention scenario I'm designing that will be located completely in sewers under a medieval town. The large sewers will have walkways either side of the effluent, so I'm wondering what would make a good fillstyle for the effluent - the only ones I can see in my install are Water Sludge #.

Also, does anyone know of where I might get some nice symbols to use - small "waterfall" as sewers empty into larges sewers and collection points, gratings (OK, I could use a portcullis) or any other sewer related symbols?

Thanks very much in advance!

jaerdaph · August 2011

I created my own fill style from the attached style for use as sewer water. I then drew the sewer water on a custom sheet called SEWERSLUDGE and added a transparency effect to it so the stone flooring beneath would show through.

I cannot remember where I found this image (I didn't create it), so consider it for personal, non-commercial use only.

jaerdaph · August 2011

And here's the original version of the image, which was initially blue (clean water) when I found it. I created a fill style to use on a dedicated sheet with a transparency effect for this as well.

Terraformer_Author · August 2011

Hey - I use a freeware caustics generator that works pretty good - here's the addy:

http://www.dualheights.se/caustics/

You can make just about any kind of refective fluid texture that you can think of with it! I used it for a project that I was working on a while back.

ProFantasy Community Forum

Sewer Dungeon Tiles?

Comments