Hello all.
I recently picked up a used Intous and have been wanting to use it in CC3+. I did read through an older thread where people had been saying that they tend to just skip using a tablet as they find a mouse easier, but I figure I have the hardware I want to be able to use it right? Plus, maybe someone has figured out how to better use one in the 3 years since that thread was posted.

I think the main problems I've been having are not properly understanding the differences between "mouse screen area," "menu area," and "real digitizing area." This is my first experience with a drawing tablet of any form. As well, I have a dual monitor setup, and I'd like to keep the tablet controlling only one of the monitors, but I can't seem to get the setup right inside of CC3+. I found the settings in the Wacom driver properties, and when using it outside of CC3+ I can use it to control just the one screen, but after a calibration in CC3+ it seems to always want to play on both screens.

Thanks for any info you have.