Not signed in (Sign In)

Vanilla 1.1.4 is a product of Lussumo. More Information: Documentation, Community Support.

Welcome Guest!
Want to take part in these discussions? If you have an account, sign in now.
If you don't have an account, apply for one now.
    • CommentAuthorHQ Yang
    • CommentTimeDec 25th 2019
     
    Is there any limit for CC3+ opening dwg or dxf file. Every time I open a dwg file, CC3+ crashs. Will it be my dwg file too complicated?
    • CommentAuthorjslayton
    • CommentTimeDec 25th 2019
     
    There are many possible reasons why the DWG file might load. The most likely reason is that some entities are too complex or of an unsupported type. How are you generating your DWG file?
    • CommentAuthorHQ Yang
    • CommentTimeDec 25th 2019 edited
     
    I trace a real Aegean Area (you know the islands OMG) in Illustrator, exported to DWG and DXF; there are two or three occasions CC3+ can load the dwg file well, but once edited in CC3+, it crashes; other occassions CC3+ crashes before edit made. And I also used Autocad for export, same happens. I tried to load a simple dwg file exported by Illustrator, CC3+ works well. So I think maybe my map just is too complex. But try to use CC3+ to trace real world map is a nightmare for me........
    • CommentAuthorHQ Yang
    • CommentTimeDec 25th 2019 edited
     
    This is the ai file I traced.
    • CommentAuthorHQ Yang
    • CommentTimeDec 25th 2019 edited
     
    Try and Err. Now I broke the above ai file into different sections and finally found the target section that has problem. This is the section that after open by CC3+ and crashed.
    • CommentAuthorHQ Yang
    • CommentTimeDec 25th 2019
     
    this is the good sections that can be open by CC3+
    • CommentAuthorHQ Yang
    • CommentTimeDec 25th 2019
     
    Here's the jpg good sections
      good section.jpg
    • CommentAuthorHQ Yang
    • CommentTimeDec 25th 2019
     
    Here's the jpg bad section
      Problem section.jpg