CC3 Glow effect not working

N1GHTMAR3 · February 2018

So, I am just starting to mess around with the software and it seems the glow effect on the land isn't working. I watched a tutorial video about CC3 and really like the glow effect, however, it doesn't do anything, no effects at all. I checked other effects and they work just fine. Any cause for that?

Monsen · February 2018

Check that your landmass is actually on the same sheet as the glow is defined on.
Also try increasing the values for strength and blur radius for the effect, they may be set too low to produce a visible effect.

N1GHTMAR3 · April 2018

Uh. Oh. I forgot about the forums' existence. I apologize...
Both strength and blur radius have been set to high numbers, it is safe to say that it is no problem of visibility.
Again, other effects do work smoothlessly.
(I haven't touched the software since the issue, but now I have a need for it).
The inner glow is working, though?...

Monsen · April 2018

Can you post your map here (or an example map with the same problem) so we can take a look at what might be wrong?

N1GHTMAR3 · April 2018

Thank you for your quick response. I can not not do that at the moment, but I will try to do so as soon as possible. I won't take months to reply, though. (Again).
Another question, can I use the inner glow's effects similar to the glow's?

N1GHTMAR3 · April 2018

Ah. This is quite embarrassing. The landmass wasn't on the same sheet, just as you suggested. Thank you. It works now. I'll go back to tutorial videos.

JimP · April 2018

We all make mistakes. I make lots of mistakes.

N1GHTMAR3 · April 2018

Well, tutorial videos are still necessary for me at the moment.

Loopysue · April 2018

I still get in quite a tangle with sheets at times. Everyone has good and bad days

N1GHTMAR3 · April 2018

Hopefully, I'll be able to create something that can be lookable at least.

Loopysue · April 2018

Of course you will. It just takes a bit of time and practice. That's all

(and a good day or two :P )

N1GHTMAR3 · April 2018

Thanks, I'll spend some more time on it.

ProFantasy Community Forum

CC3 Glow effect not working

Comments