Help Trimming Dungeon Walls

robotrock · June 2016

Probably just a noob question, but I can't seem to figure out how to deal with this. When using the corridor tool (CC3+ with DD3) I keep getting these little "nubs" of wall left over. Any help would be greatly appreciated.

JimP · June 2016

Trim could work, zoom in close. I would explain how to use the trim command, but I don't always get it to work well. And I don't want to confuse anyone.

Dogtag · June 2016

It looks like those "nubs" are left over from the corridor tool cutting the walls you're connecting to. With something that short and straight, it might be easier to just use the Delete Node tool.

Zoom in, like Jim suggested, click Delete Node and then click the center of the end of the nub (the part jutting out). It should delete the node at the end point and the wall will "retract" back to the next node, which is generally the corner of the wall.

Cheers,
~Dogtag

robotrock · June 2016

Delete Node did the job. Thank you!

Dogtag · June 2016

You're welcome. Glad I could help.

Cheers,
~Dogtag

ProFantasy Community Forum

Help Trimming Dungeon Walls

Comments